Zoom USB External Manual de usuario descargar pdf (Pagina 2)

May 15, 2013 002-1362, Rev. D, US Page 2 of 3

Frequently Asked Questions

Where do I connect the printer cable to the ZOOM LATTIUDE programmer?

A parallel port and two USB ports are located on the left side of the programmer. Select a printer cable and

corresponding port, depending on device family and print method chosen (see Figure 1 and Tables 1 / 2).

Figure 1. Left side of Programmer [1] On/Off button [2] External Printer Connector (Parallel port) [3] Two USB

ports

Which printer models have been tested and verified as compatible with the ZOOM LATITUDE programmer?

Contact Hewlett-Packard, Brother, or Samsung Customer Support. State that you need a printer with a PCL5

compatible print language, and connectivity via parallel port or USB. NOTE: The required external connector type varies

by pulse generator software application (Tables 1 and 2). Both connector types are required to be able to print

externally to the entire list of BSC products referenced.

Where do I access the Patient Data Management Utility?

The Patient Data Management Utility can be accessed from the programmer Startup screen (Figure 2). Printing is

accomplished by accessing the Print Tab (Figure 3).

Figure 2. Programmer Startup Screen

Figure 3. Patient Data Management Utility Print Tab

Does the ZOOM LATITUDE PRM support color printing?

No. The ZOOM LATITUDE PRM does not support printing in color.

Can an external printer be used while the software application is in Demo Mode?

Yes. If the PG software application has the ability to print externally (Table 1 / 2), it will print demo data while in Demo

Mode.

1 2 3 4 5 6

Sin comentarios

Zoom USB External Manual de usuario Pagina 2