Zoom 4350 Guía de instalación descargar pdf (Pagina 10)

FISH 4350 / 4380 Installation and Operation Manual10

NAVMAN

When asked Are you sure? select Yes.

Tank size

Enter the capacity of the fuel tank.

Num. engines

Set the number of engines to 0, 1 or 2. If 0 is

selected the fuel features are turned off.

Calibrate

See section 3-9 Setup > Calibrate.

Flow Þ lter

Most engines do not draw fuel from the tank at

a steady rate. To give a stable fuel ß ow reading,

the Þ shÞ nder calculates the ß ow value(s) by

taking several measurements and averaging

them. Use the Flow Þ lter to set the period over

which the fuel ß ow is averaged.

For twin engine installations, the fuel ß ow for

each engine must be adjusted separately.

The Flow Þ lter can be set from 0 to 10 seconds.

Use the lowest value which gives a stable ß ow.

Usually a value of 5 seconds (default setting)

will give a satisfactory result for two-stroke

carburettor engines.

This setting affects the Fuel ß ow and Fuel

economy reading on the Fuel display (see

section 5-5. Fuel display) but it does not affect

the Fuel used reading.

Tank full

Select Tank full each time the fuel tank(s)

are completely reÞ lled. When asked Are you

sure? select Yes. Otherwise, the reading

on the Fuel display (see section 5-5 Fuel

Display) and the Low Fuel Alarm (see section

3 -6 Setup > Alarms) are meaningless.

Set remaining

Before doing a partial reÞ ll of the tank or remov-

ing fuel manually from the tank (for example,

by siphoning it off):

1. Note the Remaining reading on the

Fuel display.

2. Note how much fuel is added or removed.

3. Calculate how much fuel is now in the

tank.

4. Select Set remaining and update

the reading.

It is essential to do this whenever some fuel

is added or removed. Otherwise, the reading

on the Fuel display (see section 5-5 Fuel

Display) and the Low Fuel Alarm (see section

3-6 Setup > Alarms) are meaningless.

Clear Used

Select Clear used to set Used (the amount

of fuel used) to zero. Do this to start measuring

the amount of fuel used over a certain time or

distance.

3-4 Setup > Data

Press MENU twice to display the Setup menu,

then select Data:

3. Press

at any data Þ eld to show the list

of data items that can be displayed there.

4. Highlight the required data item and press

. The data item is immediately displayed

in that data Þ eld.

5. Press

or MENU when Þ nished.

Time base

To change the Time base of the temperature

graph, select Time base and press

. Choose

between 5 mins, 10 mins, 20 mins, 1 hour and

2 hours and press

to conÞ rm.

Data setup

To change data items (FISH 4380 only):

1. Select Data setup, and press

2. Use

or

to move from data Þ eld to

data Þ eld.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comentarios a estos manuales

Sin comentarios