Zoom 4350 Guía de instalación descargar pdf (Pagina 5)

FISH 4350 / 4380 Installation and Operation Manual 5

NAVMAN

2 Basic Operation

Key Operation

The Þ shÞ nder is operated through menus.

To select a menu item:

1. Press

to move the highlight to the

item.

2. Press

to select the item.

To change a setting:

1. Use the cursor keys

to make the

change(s).

2. Press

to conÞ rm;

to cancel.

Power On / Auto Power

Press to turn the Þ shÞ nder on.

If the Þ shÞ nder is wired for auto power, it turns

on automatically whenever the boat’s ignition

is turned on. This ensures that the engine

hours counter and optional fuel functions are

activated. A title display appears brieß y. This is

followed automatically by the Installation menu

only the Þ rst time the Þ shÞ nder is switched

on. Use this menu to specify the language (see

section 3-1 Setup > System) and units (see

section 3-7 Setup > Units).

At all other times, the title display is followed by

the display that was used most recently.

If the transducer is not connected, the message:

No transducer detected. Enter

simulate mode? will appear. Press

select and press

to accept. (If the

transducer was not intentionally disconnected,

turn off the Þ shÞ nder and refer to the section on

Troubleshooting in Appendix B.)

Key Names

Returns to the previous menu / zooms in.

Cursor keys move the selection highlight and

change settings / scrolls up or down.

ConÞ rms changes / zooms out.

MENU Press to show the Display menu

Press again to show the Setup menu.

+ Increases the Range.

Decreases the Range.

Press and hold to power On and Off; pressing

once shows the Gain controls. Press twice to

show Backlight control.

the older echoes being scrolled towards the left,

eventually disappearing off the display.

The scroll speed depends upon the water

depth and scroll speed setting. See section

3-2 Setup > Sonar and section 4-1 Interpreting

the display, for more information.

The appearance of echoes displayed are

affected by:

• the Þ shÞ nder settings (range and gain

settings)

• echoes (different Þ sh types, different

bottom types, wrecks and seaweed)

• noise (water clarity and bubbles).

See section 4-1 Interpreting the display, for

more information.

Hold for Auto Range

1 2 3 4 5 6 7 8 9 10 ... 29 30

Comentarios a estos manuales

Sin comentarios

Zoom 4350 Guía de instalación Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Zoom 4350