Zoom 4350 Guía de instalación descargar pdf (Pagina 11)

FISH 4350 / 4380 Installation and Operation Manual 11

NAVMAN

3-5 Setup > Logs

Press MENU twice to display the Setup menu,

then select Logs:

The values can be changed independently of

each other. These log values are saved when

the unit is turned off.

Reset trip dist (FISH 4380 only)

This resets the trip distance to zero.

Reset total dist (FISH 4380 only)

This option resets the total distance to zero.

Reset engine hours

Use this option to reset the engine hours to zero.

This can be useful after an engine service or to count

the engine hours between service intervals.

c Alarm Beeper Alarm condition is

Name Cycle met when the:

Too

sec depth is less than

shallow the alarm trigger value

Too

sec depth is greater than

deep the alarm trigger value

Fish 1 short echo matches the Þ sh

beep proÞ le selected by

Þ sh Þ lter

Temp.

sec temperature equals

the alarm trigger value

Temp.

sec rate of change of

rate temperature equals the

alarm trigger value

Low

sec battery voltage is

battery less than the alarm

trigger value

Low

sec fuel remaining equals

fuel the alarm trigger value.

3-6 Setup > Alarms

Press MENU twice to display the Setup menu,

then select Alarms:

Trigger settings can be deÞ ned to suit the boat

and individual preferences as follows:

Alarms can be set (enabled) to automatically

detect certain conditions, such as the water being

too shallow. Alarms that are enabled are shown

as black icons in the Alarm status box on the

sonar displays.

When an enabled alarm is triggered, the beeper

sounds, an alarm message is displayed and the

alarm status icon is shown in red.

Press

or MENU to acknowledge the alarm,

stop the beeper and close the alarm window.

This does not disable the alarm.

Alarms automatically re-enable

The Too shallow, Too Deep and Low

battery alarms automatically re-enable

when the value moves outside the alarm

trigger setting.

The Temperature alarm automatically re-

enables when the temperature is more than

0.45°F (0.25°C) above or below the alarm

trigger setting.

The Temperature rate alarm automatically

re-enables when the rate of temperature

change falls below the trigger setting by more

than 0.2°F (0.1°C) per minute.

Flashing Light and/or External Beeper

(FISH 4380 only)

If a secondary alarm indicator is required, a ß ash-

ing light and/or external beeper can be installed.

These can be positioned anywhere suitable on

the boat. See section 6-4 Wiring options.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Comentarios a estos manuales

Sin comentarios

Zoom 4350 Guía de instalación Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Zoom 4350