
R24 Effect types and parameters
• EFX module
Parameter descriptions
Parameter
name
Setting range Description
Position
Before,After SetsconnectionpositionofEFXmoduletobeforeorafterpreamp.
Sense
−10~−1,1~10 Adjusts auto wah sensitivity.
Resonance
0~10 Adjusts resonance intensity.
Level
2~100 Adjusts signal level after passing through module.
Depth
0~100 Adjusts modulation depth.
Rate
0~50
(P124 Ta b le1) Adjusts modulation rate. Can be set in rhythm tempo note units.
Wave
Up0
~
9,Down0
~
9,Tri0
~
9
Setsmodulationwaveformto“Up”(risingsawtooth),“Down”(fallingsaw-
tooth)or“Tri”(triangular).Higher values result in stronger clipping,empha-
sizing the effect.
Color
4Stage,8State,Invert4,Invert8 Selects sound type.
Frequency
RingModulator:1~50 Adjusts frequency used for modulation.
Fix-Wah:1~50 Adjusts wah center frequency.
Balance
0~100 Adjusts balance between original sound and effect sound.
Time
1~50 Adjusts rise time for sound.
Curve
0~10 Adjusts volume rise curve.
Dry Mix
0~10 Adjusts original sound mix ratio.
RTM Mode
P124Tabl e 2 Adjusts change range and direction.
RTM Wave
P124Table3 Selects control waveform.
RTM Sync
(P124Table4) Adjusts control wave frequency.
Range
1~5 Selects frequency range to boost.
Tone
0~10 Adjusts tone.
Effect types and parameters 2
Type Parameters/Descriptions
Auto Wah
Position Sense Resonance Level
Auto wah dependent on dynamics of input signal.
Tremolo
Depth Rate Wave Level
Periodically varies the volume level.
Phaser
Position Rate Color Level
Produces a swooshing sound.
Ring
Modulator
Position Frequency Balance Level
Produces a metallic ringing sound. Adjusting the Frequency parameter results in a drastic change of sound character.
Slow Attack
Position Time Curve Level
Slows down the attack rate of the sound.
Fix-Wah
Position Frequency Dry Mix Level RTM Mode RTM Wave RTM Sync
Changes the wah frequency according to rhythm tempo.
Booster
Range Tone Level
Increases signal gain to make the sound more powerful.
Comentarios a estos manuales